Wheel Horse Forum

It is currently Sat Nov 18, 2017 5:14 pm

All times are UTC - 5 hours [ DST ]




Post new topic Reply to topic  [ 2 posts ] 
Author Message
PostPosted: Sat Sep 23, 2017 2:32 pm 
Offline

Joined: Sun Oct 30, 2011 9:56 am
Posts: 79
having done this a number of times on tractor's , its simple and takes out all the play and sloppy fit of cotter pin mounting. pto lever to clutch disk , measure where clevis point is, cut off excess thread on threaded rod. old thread is 3/8 x 16 , grind a taper on the end of that and use a 3/8 x 24 die nut right over the old thread. its simple and easy, use a 3/8x 24 female / stud fitting ,about 7$ . screw on to rethreaded rod and adjust till lever handle stops firmly at horizontal setting. having done this on two horses now, as well as heim joints at clutch rod ends. also did this on my plow blade, went from clunky sloppy fit to smooth and solid, blade angle movement is very easy. any questions , let me know, pete


Top
 Profile  
 
PostPosted: Wed Nov 15, 2017 8:31 am 
Offline

Joined: Mon Dec 20, 2004 10:24 am
Posts: 1325
Location: Mid Michigan
Took me a while to picture in my mind what you did, but once I got it (I think :oops: ) it sounds like a great upgrade. I'll have to keep it in mind.

_________________
Make the world a better place, preserve the peace, don't disturb the peace.

Image

Dale, mid-Michigan

C-101SS
C-Horse ( C-141 + Commando 800)
Kubota BX-2670


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 2 posts ] 

All times are UTC - 5 hours [ DST ]


Who is online

Users browsing this forum: No registered users and 2 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  


Powered by phpBB® Forum Software © phpBB Group