Wheel Horse Forum

It is currently Thu Oct 19, 2017 4:57 am

All times are UTC - 5 hours [ DST ]




Post new topic Reply to topic  [ 2 posts ] 
Author Message
 Post subject: PTO Lube & Torque
PostPosted: Sun Feb 19, 2017 3:16 pm 
Offline

Joined: Tue Aug 12, 2014 9:56 pm
Posts: 10
I'm finishing the install of a Kohler M12 on my 312-A. Does anyone know the torque spec for the four bolts that hold the PTO wheel onto the drive shaft? I could tell blue thread lock had been used, so I've applied that again...just not sure of the final torque. Also, should I smear some Type 2 Lithium grease into the needle bearings inside the PTO before I pin that back on?


Top
 Profile  
 
 Post subject: Re: PTO Lube & Torque
PostPosted: Fri Feb 24, 2017 12:39 pm 
Offline

Joined: Mon Dec 20, 2004 10:24 am
Posts: 1322
Location: Mid Michigan
Can't say as I ever used a torque wrench on them. Check the heads of the bolts for markings indicating their grade, check a torque specification chart for that size and grade of bolt, and go from there.

I just use grease from my grease gun on the bearings, making sure they are well coated.

_________________
Make the world a better place, preserve the peace, don't disturb the peace.

Image

Dale, mid-Michigan

C-101SS
C-Horse ( C-141 + Commando 800)
Kubota BX-2670


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 2 posts ] 

All times are UTC - 5 hours [ DST ]


Who is online

Users browsing this forum: No registered users and 1 guest


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
cron


Powered by phpBB® Forum Software © phpBB Group